1. A gap in a torsion spring
On a door with torsion springs above the opening, a visible separation in the coils can indicate a broken spring. Only observe from a safe position on the ground. Do not climb up, touch the spring or loosen nearby hardware to inspect it.
Other spring configurations look different. Not seeing a gap does not prove that the entire spring or cable system is sound. If the door is behaving abnormally, arrange an inspection.
2. A bang followed by a door that will not lift
A spring failure may make a sudden noise. If normal operation stops afterward, treat that combination seriously. A bang alone can have other causes, and it should not be used as a remote diagnosis.
Keep the door out of use. If it is partly open, keep the space underneath clear and avoid the emergency release. Let a technician decide how to secure and inspect it.
3. The door only opens a few inches
A damaged counterbalance system can leave the opener trying to move a load it should not be lifting alone. The motor may start and then stop. A sticking track, damaged hardware or an opener fault can produce similar behavior.
Do not keep pressing the remote, raise the force setting or ask someone to push while the motor runs. These attempts do not resolve the underlying cause.
4. Crooked movement or loose cables
Uneven movement and loose cables are reasons to stop using the door, whether or not the spring is the source. Cables and springs work together, and handling one component can affect the rest of the system.
Do not try to put a cable back on its drum or straighten a moving door. Describe what you can see safely and contact a trained technician.
Broken spring or garage door opener problem?
If the wall control works but one remote does not, the control system may be involved. If the door strains, tilts or stops shortly after starting, the mechanical system also needs attention. Neither comparison is a substitute for testing by a professional.
A complete diagnosis can prevent replacing an opener when a spring is the problem, or assuming a spring repair will fix an unrelated electrical fault. Ask for the cause, recommended parts and estimate before work begins.
Request help in Los Angeles
For a service request in Los Angeles, Sherman Oaks, Beverly Hills, Santa Monica or Manhattan Beach, tell AG5 your ZIP code, whether the door is closed or partly open, and what happened before the problem began. Mention any visible cable damage and whether a vehicle is trapped inside.
Photographs may help explain the situation if they can be taken from a safe location. Do not operate or reposition the door to get a better picture. Use our spring repair page to review the service, then call or request an estimate.
Further reading
For general safety guidance, see DASMA garage door safety information. For opener closing issues, consult Chamberlain Group support and the manual for your exact model. These resources do not replace an inspection.


